What do the light indicators mean?
HLTH Band Light Patterns
Your HLTH Band doesn't have a screen, so it uses a small light to show its status. Here's what each light means.
| Light Pattern | What It Means |
|---|---|
| 🔴 Solid red | Charging. |
| 🟢 Solid green | Fully charged. You'll see this while your band is still on the charger. |
| 🟢 Green flash after holding the button | Band has turned on. |
| 🟢 Blinking green | Band is ready to pair / in pairing mode. |
| 🔴 Red flashes | Interaction error. You pressed the button too firmly. |
| ⚫ No light during everyday wear | Normal. Your band only lights up when you press the button or when it's charging. |
| ⚫ No light at all, even when you press the button or put it on the charger | The battery is probably empty. See below. |
What to Do
Solid red: Your band is charging. Leave it on the charger until the light turns solid green. A full charge takes about 90 minutes, and just 10 minutes gives you around 3 days of use.
Solid green: Your band is fully charged. You can take it off the charger and wear it.
Turning your band on: Hold the side button for about 3 seconds until the light flashes green.
Blinking green: Your band is ready to pair. Open the QWatch Pro app and follow the pairing steps. See How to Set Up and Pair Your HLTH Band for the full guide.
Red flashes: The button is sensitive. Try again with a short, light tap rather than a firm press. This isn't a fault with your band.
No light during everyday wear: This is normal, and your band is still tracking. To check its status, give the button a short, light tap.
No light at all, and nothing happens when you press the button: The battery is empty. Charge it fully (about 90 minutes), then hold the side button for about 3 seconds until the light flashes green.
Which charger do I have?
Your HLTH Band comes with a magnetic charging cable in one of two versions. Both work exactly the same way:
- USB-C: the small oval plug, used by most newer phones and laptops
- USB-A: the flat rectangular plug, used by most older chargers, plug adapters and computers
The magnetic end that attaches to your band is the same on both.
Please note: A wall adapter isn't included. You can use any certified USB wall adapter or computer USB port that matches your cable's plug.
My band shows no light and won't charge
- If your band is new, check you've peeled the clear protective film off the sensor unit
- Check the magnetic cable has clicked onto the two charging contacts on the back of your band. It only fits one way, so if it doesn't click, turn it over.
- Make sure the charging contacts are clean and completely dry. Wipe them with a dry cloth, and don't charge your band if they're wet.
- Push the plug fully into your power source, and check the port matches your cable (USB-C or USB-A)
- Try a different wall adapter or USB port
If there's still no light after these checks, see What to do when my band isn't charging? or email us at info@hlthtrack.com.
Still need help? Email us at info@hlthtrack.com.