What to Do When Your Band Isn't Charging
If your HLTH Band isn't charging, it's usually a quick fix. Work through these steps in order.
First, check your cable: does the end that plugs into your wall adapter or computer have a USB-A or USB-C connector? Knowing this helps you match the right adapter.
How Charging Works
When your band is charging, the light shows solid red. When it's fully charged, it turns solid green.
A full charge takes about 90 minutes. You don't need to wait that long to check it's working, though: 10 minutes on the charger gives around 3 days of use, so a short charge is enough to tell whether it's charging.
Battery life varies depending on how often your band syncs and how often you use workout tracking.
Step 1: Remove the Protective Film
New bands come with a clear protective film on the sensor unit. If it's still on, the cable can't reach the charging contacts. Peel it off and try again.
Step 2: Check the Magnetic Connection
The charging cable attaches magnetically to the two charging contacts on the back of your band.
The magnetic end only fits one way. If it doesn't click into place, turn it over and try again.
Make sure it sits directly over the contacts, not just near them
Check for a solid red light. See What Do the Light Indicators Mean? if you're not sure what you're seeing.
Step 3: Make Sure the Contacts Are Clean and Dry
Sweat, moisture or dirt on the contacts can stop your band from charging.
Wipe the contacts on the back of your band with a clean, dry cloth
Check the magnetic end of the cable for dirt and wipe it clean
Make sure everything is completely dry before reconnecting. Never charge your band while the contacts are wet.
Step 4: Try a Different Power Source
The problem may be the power source rather than your band.
Check which cable you have: USB-C (small oval plug) or USB-A (flat rectangular plug). Make sure the port or wall adapter matches.
Try a different certified USB wall adapter or computer USB port
Avoid USB hubs with several devices connected, as they may not supply enough power
Check the port works by plugging something else into it
A wall adapter isn't included with your band, but any certified USB wall adapter will work.
Step 5: Check the Cable for Damage
Look for:
Fraying, kinks or other visible damage
Dirt on the magnetic connector
Bent or damaged pins on the connector
If your cable looks damaged, stop using it and contact us. Chargers are covered the same way as your band while it's under warranty, at no extra cost.
Step 6: Turn Your Band On
Once it has some charge, hold the side button for about 3 seconds until the light flashes green.
If Your Band Is Completely Flat
A band that hasn't been charged for a while, for example after being left in a drawer, can take longer to respond.
Leave it on the charger for at least 10 minutes. The light may not come on straight away, and this is normal.
Once it starts charging, leave it for the full 90 minutes, then hold the side button for 3 seconds until the light flashes green
Open the QWatch Pro app so your band can reconnect and sync
When to Contact Us
Leave your band on the charger for 1 to 2 hours, using the original HLTH cable
If there's still no solid red light, email us at info@hlthtrack.com
Please include:
Your order number
A photo or short video of your band on the charger
Which power sources you've tried
Whether your band was working before this started
Important
⚠️ Only use the charging cable supplied with your band. Other magnetic cables may not fit properly and could damage your band or its charging contacts.
⚠️ Never charge your band while the contacts are wet. Dry them completely first to avoid a short circuit.
Still have questions? Email us at info@hlthtrack.com.